Pioneer VSX-819H-K Service Manual page 10

1
also used to change the name.
A
BAND
Switches between AM, FM ST (stereo) and FM MONO
radio bands.
CATEGORY
Press to browse SIRIUS radio broadcasts.
Press iPod USB fi rst to access:
iPod CTRL
Switches between the iPod controls and the receiver
controls.
9 (TUNE / , PRESET
B
Use the arrow buttons when setting up your surround sound
system. Also used to control BD/DVD menus/options.
Use the TUNE / buttons can be used to fi nd radio
frequencies and the PRESET
select preset radio stations.
10 Component control buttons
The main buttons ( , , etc.) are used to control a
component after you have selected it using the input source
buttons.
The controls above these buttons can be accessed after
you have selected the corresponding input source button
C
(for example BD, DVR or TV). These buttons also function
as described below.
Press RECEIVER fi rst to access:
BASS –/+
1
Use to adjust Bass
TRE –/+
1
Use to adjust Treble
Press TV fi rst to access:
ANT
Use to select the VHF/UHF antennas or Cable TV.
11 Number buttons and other component controls
D
Use the number buttons to directly select a radio frequency
or the tracks on a CD, DVD, etc. There are other buttons
that can be accessed after the RECEIVER button is
pressed. (For example MIDNIGHT, etc.)
HDD*, DVD*, VCR*
These buttons switch between the hard disk, DVD and
VCR controls for HDD/DVD/VCR recorders.
S.RETRIEVER
Press to restore CD quality sound to compressed audio
sources.
EQ
E
Press to switch on/off Acoustic Calibration EQ setting.
CH SELECT
Press repeatedly to select a channel, then use +/– to
adjust the level.
CH SELECT +/–
Use to adjust the channel level.
SB CH
Press to select ON, AUTO, OFF the surround back
channel.
PHASE
Press to switch on/off Phase Control.
DIMMER
F
Dims or brightens the display. The brightness can be
controlled in four steps.
SPEAKERS
10
1
2
/ ), ENTER
/ buttons can be used to
VSX-819H-K
2
3
Use to change the speaker system.
MIDNIGHT
Switches to Midnight or Loudness listening.
SLEEP
Press to change the amount of time before the receiver
switches into standby (30 min – 60 min – 90 min –
Off). You can check the remaining sleep time at any
time by pressing SLEEP once.
Press SIRIUS fi rst to access:
D.ACCESS
After pressing, you can access a radio station directly
using the number buttons.
12 SOURCE
Press to turn on/off other components connected to the
receiver.
13 TV CONTROL buttons
These buttons are dedicated to control the TV assigned to
the TV button. Thus if you only have one TV to hook up to
this system assign it to the TV button.
Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes/unmutes the sound.
16 DISPLAY
Switches the display of this unit. The input name, listening
mode or sound volume can be checked by selecting an
input source.
17 SHIFT
Press to access the 'boxed' commands (above the buttons)
on the remote. These buttons are marked with an asterisk
(* ) in this section. This button is also used for operating
ZONE 2.
Note
1 The tone controls are disabled when the listening mode
is set to DIRECT or PURE DIRECT.
3
4
4