Bot Id And Eot Id; Functions And Operations; Monitor - RCA BRM1250 Instruction Manual

14

BOT ID and EOT ID

Your dealer may configure whether to transmit
Connect ID (BOT ID) and Disconnect ID (EOT
ID), when connecting or disconnecting a
repeater or telephone system. The following
modes are programmable:
1. Press the PTT key, and the BOT ID is
transmitted.
Release the PTT key, and the
EOT ID is transmitted.
2. Press the * key while holding down the PTT,
and the BOT ID is transmitted.
Press the # key while holding down the
PTT, and the EOT ID is transmitted.

FUNCTIONS AND OPERATIONS

Monitor

If the Monitor function is set by your dealer,
press the programmed Monitor key in Rx
Copyright © 2011 Discount Two-Way Radio Corporation - North American Distributor
BRM1250 Professional Mobile Two-Way Radio Instruction Manual
TM
mode to gain access to the activities on the
current channel.
The Monitor key is programmable with one
of the following four operating modes by your
dealer:
1. Carrier Squelch-Momentary: Hold down the
Monitor key to open CTCSS/CDCSS/2-Tone
Signaling squelch, and release the key to
close the Signaling squelch.
2. Carrier Squelch-Toggle: Press the Monitor
key to open CTCSS/CDCSS/2-Tone Signaling
squelch. Press again to close the Signaling
squelch.
3. Squelch Off-Momentary: Hold down the
Monitor key to open carrier squelch, and
release the key to close the carrier squelch.
4. Squelch Off-Toggle: Press the Monitor key
to open carrier squelch. Press again to close
the carrier squelch.