Table of Contents
Advertisement
BRM1250
Receiving a Call
If
CTCSS/CDCSS,
2-Tone,
RDC2400 is set on the current channel by your
dealer, you can only receive calls with matched
signaling. If CTCSS/CDCSS, 2-Tone, MDC1200
or RDC2400 is not set, you can hear from all
the users on the same channel.
Transmitting a Call
When transmitting a call, please follow the
steps below:
1. Hold down the PTT key on the microphone.
2. Speak into the microphone. The red LED
lights during calling.
3. Release the PTT key to return to the RX
mode.
4. When the transmission ends, put the
microphone on the hook.
Copyright © 2011 Discount Two-Way Radio Corporation - North American Distributor
Professional Mobile Two-Way Radio Instruction Manual
TM
Selecting the Power Level
MDC1200
or
If the current channel is programmed with
high power by your dealer, the power output
toggles between high and low upon each
press of the programmed Tx Power Select key.
The LO icon is displayed on LCD to indicate low
power.
A lower power level saves battery and reduces
the possibility of interference. Use the high
power setting only when necessary.
Note:
• If the current channel is programmed with
• If you switch to low power on a channel that
lower power, any Tx Power Select key press
will prompt an error tone, and the power
level will not change.
was set with high power, this configuration
will work on all other channels that were set
with high power.
13
Advertisement
Table of Contents
