Linear TE Configuration Manual

TE Front Panel Guide and
Configuration Manual
3. Create a New Admin Code
All panels require a new
password upon start up.
Enter the initial four digit
entry code, you'll be
prompted to enter and
verify a new Admin Code.
Note: If an error is made entering the code, you will be
prompted. Follow on-screen instructions, then try again.
1. Navigation
The HOME button will take
you "back" to a previous
screen.
Pressing HOME repeatedly
will eventually return you to
the WELCOME screen.
Use the Cursor buttons
( ˄ , ˅ , < or > ) to highlight
an option, then press
make and/or save settings.
Use the Number buttons to
make numeric entries.
(EN-2A4)
4. Panel Settings
After successfully entering
a new Admin Code, the
Panel Settings screen is
displayed.
IMPORTANT: If the Panel
Settings screen times out
or you leave the screen
voluntarily, refer to the
process described in Step
5 to return to the Panel
Settings screen. Otherwise,
proceed to step 6.
to
2. Enter Admin Code
The first screen displayed
will be blank. Use the
number buttons to type the
provided four digit Admin
Code: "1-2-3-4".
Entries will be represented
by asterisks. Press to
enter the code.
Note: If an error is made
entering the code, you will
be prompted. Follow on-
screen instructions, then
try again.
5. Returning to Panel Settings Screen
1. Press the HOME button
until you arrive at the
Building Name/Address
screen.
2. Highlight the Gear icon
( ), then press .
3. At the Settings screen,
enter 99, press the
HOME button and
then enter the Admin
passcode.
The Panel Setting screen
should be displayed. If
not, repeat the three steps
listed above.