Add Ip Filter - D-Link DWR-932 User Manual

Section 3 - Configuration
If you selected Add New IP Filter:

Add IP Filter

Protocol
Select the protocol for ports that you want to allow or
deny access to. Choose between TCP, UDP or ICMP
or all of the above.
Source IP
Enter the source IP address that you wish to filter.
Subnet
Enter the subnet mask of the source IP address you
wish to filter.
Source Port Number
Enable this feature if you wish enter a single port or a
range of ports to be filtered based on origin. Disabling
this feature will cause all incoming connection fitting
other criteria to be filtered.
Source Port Range
Enter an incoming port range to which your filter will
apply.
Dest IP
Type in the destination IP address. Leave this blank
to apply your filter to incoming connections to any
destination IP
Destination Port
Click the toggle if you wish enter a single port or a
Number
range of ports to be filtered. Separate port numbers
with a comma.
Destination Port Range
Enter a destination port range to which your filter
will apply.
D-Link DWR-932 User Manual 42