Installation; Initial Setup - D-Link DWR-932 User Manual

Section 2 - Installation
This section will guide you through the installation process.
1. Remove the battery cover on the back of the device by gently prying it up from the case
using the corner notch, then remove the battery.
2. Note the SSID (network name) and password on the label on the battery cover. If you want
to connect to the DWR-932 wirelessly, you will need to enter this SSID and password.
3. Slide the SIM card frame to the right and lift up. Insert the SIM/UICC card into the SIM/
UICC card slot as shown, ensuring the gold contacts are facing down. Replace the frame
and slide it left to lock it in position.
Note: If you wish to use the onboard storage functionality,
you may install a microSD at this time.
4. Reinsert the battery and replace the battery cover.
5. Connect the Micro USB end of the USB cable to the Micro USB port on the bottom of the
DWR-932C and plug the other end into the USB port of the power adapter (not included)
or PC to charge the battery.
6. Press and hold the power button for three seconds to turn on the device. Once the power
LED changes from green to solid blue or amber, you may proceed with configuration.
Note: Always unplug and turn off the router before installing or removing the SIM card. Never
insert or remove the SIM card while the router is in use.
D-Link DWR-932 User Manual

Installation

Initial Setup

1.
2.
SI M
3.
SI M
7