Graco ULTRA MAX II 695 Quick Operator's Manual page 2

SPRAYING
Turn safety lever
of gun to OFF.
SHUTDOWN AND CLEANUP
Set power
Trigger gun until
switch to OFF.
pressure is relieved.
Unscrew tip & guard
from gun. Clean gun filter, Place drain
inlet screen, tip, guard tube and
and manifold filter with siphon tube
water and brush. in pail of water.
Place drain tube in waste Set power switch to ON,
pail and siphon tube in and increase pressure
container of Pump Armor ™ until sprayer starts.
AUTOCLEAN 2 ™ GUIDE
Remove suction and drain tubes from
paint. Place drain tube into waste pail
and wipe suction tube clean.
Place gun in Screw connector
AutoClean connector. onto gun.
Unscrew connector from gun.
When finished, remove
Remove gun from connector.
trigger clip from gun handle.
GRACO N.V. • Industrieterrein Oude Bunders
Slakweidestraat 31 • B-3630 Maasmechelen
Tel. (32) 89 770 700 • Fax (32) 89 770 777
Point gun at area to be sprayed about 30 cm from surface, and begin moving gun before triggering.
A good spray pattern is evenly distributed as it hits surface. Set pressure just high enough to spray without heavy edges.
Use smaller tip size for thinner material and a larger tip size for thicker material if pressure adjustment cannot achieve even spray pattern.
* for AutoClean 2 ™ : see bottom of this page
Turn prime valve
to Prime position Remove gun filter
(down). assembly.
Turn pressure control knob
to lowest setting, set power
switch to ON, and increase
pressure until sprayer starts.
Let sprayer run and flush itself
for 2 minutes.
As soon as Pump Armor
comes out of drain tube,
set power switch to OFF.
Place suction tube in Close drain valve.
appropriate cleaning fluid. Switch power ON.
Slide open end
over back of handle.
Close drain valve.
Remove manifold
filter and spacer.
Keeping gun triggered Keep gun triggered
into water pail, turn prime into pail for 1 minute,
valve to Spray position until water coming
(horizontal). out of gun is clean.
Screw inlet screen onto
Wipe outside of sprayer,
siphon tube, replace
hose and gun with rag
manifold filter and spacer,
soaked in water or
and assemble gun with
mineral spirits.
filter, tip and guard.
To save paint from hose and pump,
trigger gun into paint pail and increase
pressure. When cleaning fluid appears,
release gun trigger.
Rotate trigger lock
clip 90° to lock
trigger open.
With clean fluid, briefly trigger gun
into waste pail several times to
clear any debris from front of gun.
© 2002, 2006 Graco N.V. · Form No. 328006 E (rev.B)· 07/06 · Printed in Europe.
All info r m a t i o n , i l l u s t ra t i o n s, and specifications in t his document are based on t he latest product info r m a t i o n
a vailable at the time of publication. The right is re s e rved to make changes at any time wit hout notice.
Unscrew inlet screen
Assemble gun
from siphon tube.
without filter.
Set power switch to OFF,
turn pressure control knob to
lowest setting, and turn prime
valve to Prime position (down).
Fill throat packing nut
with TSL ™
Turn pressure all the way down.
Open drain valve.
Press display button
until timer appears and turn
pressure control knob to highest.
Install tip and guard and briefly trigger
gun into waiste pail to clean tip.
Reverse tip if necessary.
Graco is registered ISO 9001.