Warnings And Safety Information; Before You Start - Fisher & Paykel OS302 Installation Instructions Manual

Warnings & safety information
WARNING
CAUTION!
In order to avoid hazard these products
must be installed according to these
instructions.
Please follow installation information
carefully. If in doubt consult your local
building authority by-laws.
Failure to install the product correctly
could invalidate any warranty or liability
claims.
The product is to be installed only by an
authorised person.
IMPORTANT!
Please make this information available
to the person responsible for installing
the product as it could reduce your
installation costs.
Read these instructions carefully before
installing or using this product.
4
Cut Hazard
Take care - panel
edges are sharp.
Failure to use caution
could result in minor
injury or cuts.

Before you start

Ensure a suitable disconnection switch
is incorporated in the permanent wiring,
mounted and positioned to comply with
the local wiring rules and regulations. A
means of disconnection with at least a
3mm air gap contact separation in all poles
must be incorporated into the fixed wiring
in accordance with the wiring rules, unless
the local wiring rules allow for the following
variation. A means of disconnection from
the supply having an air gap separation
in all active (phase) conductors must be
incorporated in to the fixed wiring.
We recommend that the outlet for the
electrical supply cable is located in the
right rear corner of the cabinet cavity.
This allows the electrical supply cable to
sit inside the rear chamfered corner of
the oven and prevents it being jammed
between the cabinet wall and the rear of
the oven.
Ensure the benchtop and the oven cavity
are square and level.
The oven support surface should be flat,
level and be able to support a weight of at
least 190kg for double oven models and
108kg for single oven models.
Ensure the electrician provides sufficient
free length of mains cable to reach from
the bottom rear of the cavity to at least 1.5
metres in front of the bottom edge of the
opening. The cable may enter the cavity
from the side, top or bottom, but top entry
must be at the rear of the cavity.
Use easy to clean finishes for the wall
surfaces surrounding the oven and cooktop
to aid in removal of any cooking fume
staining resulting from the use of the oven
and cooktop.
Check the height from the floor suits the user.
Ensure that drawers and doors will be clear
of obstruction when fully opened.