Related Manuals for Fisher & Paykel MINIMAL OS24SDTDB1
Summary of Contents for Fisher & Paykel MINIMAL OS24SDTDB1
- Page 1 STEAM OVEN MINIMAL OS24SDTDB1, OS24SDTB1 CONTEMPORARY OS24SDTDX1, OS24SDTX1 INSTALLATION GUIDE US CA...
-
Page 2: Safety And Warnings
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THIS GUIDE WARNING! To avoid hazard, follow these instructions carefully before installing or using this appliance. WARNING! Electric Shock Hazard Please make this information available to the person installing the appliance—doing so could reduce your installation costs. -
Page 3: Before Installation
INSTALLATION CONSIDERATIONS BEFORE INSTALLATION AFTER INSTALLATION Ensure that: Ensure that: the oven cavity is square and level based on the required dimensions the oven door can open fully without obstruction the installation will comply with all clearance requirements and applicable standards and the oven is not sealed into the cabinetry with silicone or glue. -
Page 4: Installation Kit
COMPONENTS STANDARD ACCESSORIES KIT INSTALLATION KIT Supplied with all models. Part No. 580722 Supplied with all models. Broil pan Grid Broil rack Food probe Screws (2) Metal side shelves fixing nut (2) Full extension sliding shelf Step down wire shelf STEAM ACCESSORIES KIT Part No. -
Page 5: Product Dimensions
PRODUCT DIMENSIONS FRONT PROFILE OS24SDT MODELS PRODUCT DIMENSIONS INCHES A Overall height of oven 23 9/16 B Overall width of oven 23 7/16 C Overall depth of oven (excluding handle and dials) 22 1/4 D Height of chassis 22 5/8 E Width of chassis 21 7/8 F Depth of chassis... -
Page 6: Cabinetry Dimensions
CABINETRY DIMENSIONS PROUD INSTALL 5/8 - 13/16" (16-20mm) PROFILE PLAN FLUSH INSTALL OS24SDT MODELS CABINETRY DIMENSIONS INCHES 5/8 - 13/16" A Minimum inside width of cavity 21 1/16 (16-20mm) B Overall width of cabinetry 23 5/8 C Minimum inside height of cavity 22 13/16 D Overall height of cabinetry 23 5/8... - Page 7 DISCARD PACKAGING RESPONSIBLY Remove the packaging from the side and accessories box from the top of the oven, and set aside. Recycle responsibly...
-
Page 8: Electrical Specifications
ELECTRICAL CONNECTION ELECTRICAL SPECIFICATIONS NAMEPLATE LOCATION OS24SDT MODELS nameplate VOLTAGE MAX. CURRENT DRAW MAX LOAD location under control panel 208 V 16.5 A 3.4 kW 240 V 19 A 4.5 kW JUNCTION BOX LOCATIONS junction box location for undercounter installation junction box location for wall installation... -
Page 9: Three-Wire Connection
CONNECT THE OVEN TO THE MAINS SUPPLY THREE-WIRE CONNECTION FOUR-WIRE CONNECTION cable from cable from power supply power supply white wires wires wires black wires black wires green grounding U.L.-listed white and green oven wires - conduit grounding oven U.L.-listed factory taped connector wires - factory... -
Page 10: Secure The Oven To The Cabinetry
SECURE THE OVEN TO THE CABINETRY cavity Do not lift the oven by the door handle. Do not over-tighten the screws. Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult. Fisher & Paykel will not cover the costs of removing the Position the oven in the prepared cavity. -
Page 11: Installer Checklist
INSTALLER CHECKLIST TO BE COMPLETED BY THE INSTALLER TEST OPERATION: Ensure the oven is level and securely fitted to the cabinetry. Turn on the oven. The display should light up. Open the oven door slowly until it is fully open and check there is adequate Set the clock and mains voltage supply following the instructions in the ‘User clearance between the bottom of the door and the lower trim. - Page 12 FISHERPAYKEL.COM © Fisher & Paykel Appliances 2021. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue.