Table of Contents
Advertisement
Installation and operating manual
1.4. Transport and storage
Despite our utmost care and attention it is not possible to rule out transport damage. Please therefore remove all packaging
material immediately after receipt and inspect the product for any possible transport damage. Any damages must be
immediately notified to the transport company and BEKO TECHNOLOGIES GMBH or one of their agents.
CAUTION!
Damage caused during transport or storage
Incorrect transport, storage or the use of unsuitable lifting equipment can cause damage to the
device.
•
•
•
•
NOTICE
Recycling of packaging material
•
6
The device may only be transported and stored by authorised and trained personnel.
The device must not be operated with any damages.
Always comply with the permissible storage and transport temperatures (refer to technical
data).
Protect the device against continuous direct sunlight and heat radiation.
The packaging material is recyclable. Dispose of the packaging material according to the
applicable statutory guidelines, provisions and regulations of the country concerned.
The device must be stored in the original
packaging in a closed, dry and frost-free room.
Ensure that the ambient temperature and
storage conditions do not undershoot/exceed
the details stated on the rating plate.
The device must be protected against the
effects of external weather even when it is in a
packaged condition.
While in storage, secure the device so that it
cannot topple over or fall, and protect it against
vibration.
DRYPOINT
EN
M eco control
®
Advertisement
Table of Contents
