2. Pattern Check
Note:
When the NG (Red) indicator of "Position" lights during checking, does not care about it (It is normal performance).
1)
Turn the focus ring slowly from the near end "Focus Pattern : 1" to the infinity end "Focus Pattern : 27" and check that the value of
"Focus Pattern" change from 1 to 27 continuously.
2)
Turn the focus ring slowly from the infinity end "Focus Pattern : 27" to the near end "Focus Pattern : 1" and check that the value of
"Focus Pattern" change from 27 to 1 continuously.
[Exit]
3)
Click the
[End]
4)
Click the
5)
Turn the POWER switch of the camera to OFF.
6)
After the pattern check is completed, apply the adhesive bond (B-10) as shown in Fig. 4-6-8.
SAL50F14 (1.4/50) (50mm F1.4)
button.
button to terminate the lens adjustment program.
Hold Sheet
Hold Sheet Tape
h
h
h
h
h
Fig. 4-6-7
Brush Hole Cover
Apply the adhesive bond (B-10)
Fig. 4-6-8
4-19
Focus Brush