Table of Contents
Advertisement
3-4 Setting the Date and Time
The current date and time are shown in the display
when the machine is on and ready for use (Standby
mode). The date and time are printed on all faxes
you send.
1 . Press Menu, then press Date & Time on the one-
touch keypad.
The display shows the currently set date and
time.
1 1 - 2 7 - 1 9 9 8
0 8 : 3 6 ( P M )
e.g. 12 HOURS format
1 1 - 2 7 - 1 9 9 8
2 0 : 3 6
e.g. 24 HOURS format
2 . Enter the correct date and time using the
number keypad.
DD (Day)
= 01~31
MM (Month)
= 01~12
Y Y (Ye a r )
= four digits (1990~2089)
HH (Hour)
= 00~23 (24 HOURS format)
= 01~12 (12 HOURS format)
MM (Minute)
= 00~59
AM (Ante Meridiem)
PM (Post Meridiem)
3 . Press Enter when the date and time in the
display is correct.
If you enter an invalid number, the machine beeps
and doesn't proc ee d to the nex t st ep. If t his
happens, just reenter the correct number.
The display shows the date and time you have
s e t , t h e n returns to Standby mode.
Samsung Electronics
3-5 Setting the System ID
(Your Number and Name)
The System ID will be printed at the top of each
page sent from your machine.
1 . P re s s Menu, t h e n p re s s System ID on the
one-touch keypad. The display asks you to enter
the telephone number.
I f t h e re is a number previously re g i s t e re d , t h e
number appears.
2 . Enter the telephone number (up to 20 digits)
which your machine is connected to. You can
include the space using Pause button.
If you make a mistake, pre s s ˆ o r ¤ to move the
cursor under the wrong digit, then enter the
c o r rect number to change or pre s s Delete t o
delete the number.
3 . P re s s Enter when the number in the display is
c o r rect. The display asks you to enter your ID
name.
4 . Enter your ID name (up to 20 characters).
You can enter alphanumeric characters using the
number keypad, and include special symbols
such as + by pressing 0 r epeatedly.
If you want to enter the same letter or number in
s u c c e s s i o n ( e . g . S S , AA, 777), enter one digit, then
move the cursor by pressing Right, and enter the
n e x t d i g i t .
If you want to insert a space in the name, you can
a l s o u s e ¤ button to move the cursor to skip the
position.
5 . P re s s Enter when the name in the display is
c o r re c t .
Setup and Installing
3-15
Advertisement
Table of Contents
