Table of Contents
Advertisement
Table 36. Assembly material
Description
#6-32 screw
Power interface board (PIB)
Removing PIB
Prerequisite
1
Ensure that you read the Safety instructions.
About this task
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized is not covered by warranty. Read and follow the safety instructions that came
with the product.
Before attempting to service any part of the Power Interface Board (PIB), make sure the power source and power cables are turned off
and disconnected.
It is not necessary to remove the PIB cover. The following procedure is provided as reference information only.
Steps
1
Make sure the system is turned off. Log in to the interface. The command line interface (CLI) is displayed.
2
Change directory locations to the specified directory as shown in the following figure.
3
Type the command Stop to turn off the system. The turn-off process is fully completed in 2 minutes.
Quantity
2
Installing and removing system components
Torque (lbs/inch)
8 ± 0.5
Installation and Service Manual
137
Advertisement
Table of Contents
