(3) Remove one cable tie.
(4) Undo one screw and remove two ground wires.
(5) Disconnect three connectors. (Four connectors for the model "V-R200-BD" (Dallas key built in model)).
Cable tie
V-R200-BD (Dallas key built in model) only
A-2. Remove the following parts.
(1) COVER/SHEET (Screw (S8)
(2) COVER/BATTERY (Screw (S3)
(3) COVER/CONNECTOR (COVER-USB)
(4) COVER/SD (Screw (S8)
(4) COVER/SD (S8)
(3) (COVER/USB)
(3) COVER/CONNECTOR
Connector
1
1)
2)
1)
Note on reassembling
0 Put the lead wires of the speaker in the case.
Screw (S2)
Ground wire
– 37 –
V-R200 / VER.1
2
Connector
3
(2) COVER/BATTERY (S3)
(1) COVER/SHEET (S8)