How To Attach The Exclusive Operator (Nes1-Op); How To Attach The Exclusive Operator - Hitachi NES1-004SB Quick Reference Manual

5.3 How to attach the Exclusive operator (NES1-OP)

1) Remove the front cover from main body
3) The connector of the exclusive operator (NES1-OP)
connect to the connector on the circuit board. And attach it
to put the circuit board.
4) Attach the front cover.
Note) Please set SW4, SW5 on the board, before installation of exclusive operator (NES1-OP).
2) Cut the standard operator panel by in thin–blade-nipper and
take it off.
5) Figure of installation (NES1-OP)
5 - 3
Chapter 5 Wiring
Cut (6 points)