Table of Contents
Advertisement
Add 9/16" to X. Record this measurement.
Cut the threaded end of the spout so that it extends
9/16" + X from the rear of the flange.
Remove the aerator (1).
Wrap the threads on the spout with Teflon tape.
Install the sealing ring and spout. Use a rod or dowel
inserted into the end of the spout to assist in tightening
it (2).
Do not overtighten the spout, or damage may
result.
Tighten the spout flange against the wall (1).
Install the aerator (2).
Push the sealing ring and handle over the rough.
Rotate the handle flange clockwise, so that it threads
down over the extension spindle (3).
Model 16532XX1 only: Install the screw covers.
5
Advertisement
Table of Contents
