Table of Contents
Advertisement
G-Force 850 b/g Broadband Wireless Base Station
User's Manual
RF Setup: Configuring the Wireless Transceiver
The RF Setup page allows you to change the wireless transceiver settings.
Figure 7.
Network > RF Setup
The options are as follows:
Wireless Mode
Channel
Beacon Interval
Rate Selection
12
Sets the IEEE wireless mode used by the base
station: 802.11b/g, 802.11b only, or 802.11g only
Sets the frequency channel used by the transceiver.
The options range from 2.412GHz to 2.462GHz in
increments of 0.005GHz.
Sets the interval on which the device transmits a
beacon signal in milliseconds. The recommended
interval is 100ms, but may be set anywhere between
25ms and 500ms.
Sets the rate selection algorithm used by the base
station: Once or Single. Select Once for clean signal
environments, and Single for noisy signal
environments.
Version 0.1
Advertisement
Table of Contents
