August 2015
7
Working at the top of the 4 inch / 10 cm mast
section, use a drill to remove the rivets
securing the wear pads in position.
8
Remove the 3 inch / 7.5 cm mast section from
the 4 inch / 10 cm mast section. Disconnect
the cable from the 4 inch / 10 mast section by
removing the cable retention pin.
9
Remove the clevis pin and sheave from the
2 inch / 5 cm mast section.
10 Remove the clevis pin and sheave from the
3 inch / 7.5 cm mast section.
11 Remove the clevis pin and sheave from the
4 inch / 10 cm mast section.
Note: For ease of assembly, note the location
where each wear pad is removed.
Note: To ensure that the mast extends properly
after assembly, carefully measure the cable to
confirm that the new cable is the same length as
the old one.
Note: During assembly, carefully install the mast
cable. Refer to the illustration on the following page
for cable routing.
Part No. 1266665
RL4 Vertical Mast
Service Manual
Mast
51