Camera Control (3) (For Table Mode 2) - Panasonic LP-ABR11 Setup And Operation Manual

7.6

Camera Control (3) (for table Mode 2)

Term Command
DDMcapmode=
Left,
Capturing area Top,
Width,
Height
Illumination
DDMlight=a
Control
Internal DDMled=
Illumination a,b,c,d,e
Internal
DDMbrightness=
Illumination
a,b,c,d,e
Brightness
Shutter Speed DDMshutt=a
Analg Gain DDMgain=a
Digital Gain DDMexgain=a
Black Level
DDMblack=a
adjustment
Image DDMpreproc=
Preprocessing a,b,c,d,e
Mirrored image DDMmirror=a

The default value is same in Table 0 to 8.
Description
Specify capturing area of the table
Left 0 to 1275
Top 0 to 955
Width 4 to 1280 1280 (*)
Height 4 to 960 960 (*)
Set ON/OFF of illumination output
a=2; Internal illumination OFF [Fixed]
a=3; Internal illumination ON [Fixed](At imaging) (*)
a=4; External illumination ON (At imaging)
a=5; External illumination ON(Always)
a=6; External illumination ON(During attempting to read:
SYNCMODE=for 1 or 2)
a=7; Interenal and External illumination ON (at imaging)
a=8; For test † DO NOT USE
a=9; Interenal and External illumination ON(During attempting to read)
a=10; For test † DO NOT USE
a=11; Internal illumination ON (During attempting to read)
Set the type of internal illumination source
Set the type of internal illumination source
a: Internal illumination TOP
b: Internal illumination LEFT
c: Internal illumination RIGHT
d : Internal illumination BOTTOM
e: Internal illumination CENTER
Setting of a to e = 0: Illumination OFF1: Illumination ON
a,b,c,d,e = 1,1,1,1,1 (*)
Set the brightness of internal illumination source
a: Internal illumination TOP
b: Internal illumination LEFT
c: Internal illumination RIGHT
d : Internal illumination BOTTOM
e: Internal illumination CENTERSetting of a to e = 0 (OFF) to 100
(Brightest)
a,b,c,d,e = 80,80,80,80,80 (*)
Set the shutter speed of the Table
a : 0 to 8
a= 0; 1/60 [sec]
3; 1/500
6; 1/4000
9: 1/10000
Set the Analog gain of the table
a= 1 (Dark) to 4 (Bright)
a=3 (*)
Set the Analog gain of the table
a= 1 (Dark) to 15 (Bright)
a=1 (*)
This is a parameter for test. Set it 0 always.
a=0 (*)
Set the type of preprocessing
a,b,c,d,e : Command for Preprocessing (Described later)
a,b,c,d,e =0,0,0,0,0 (*)
Up to 5 stage of function can be set by CSV
Set the mirrored image of Table.
a=0; Read only normal type (not mirrored) (*)
a=1; Read only mirrored type
a=2; Read normal type and if it fails, try to read it as mirrored type
85
(*)=Default
0 (*)
0 (*)
1; 1/125 2; 1/250 (*)
4; 1/1000 5; 1/2000
7; 1/6000 8; 1/8000