Lan (Tcp/Ip) Connection; Preparation; Configure Ip Address - Panasonic LP-ABR11 Setup And Operation Manual

6 LAN (TCP/IP) connection

6.1

Preparation

Configure the network setting to use the LAN interface.
6.2

Configure IP address

6.2.1 Configure through RS232C interface
Connect the reader to a PC through a RS232C cable.
Start a terminal software "Configurator LP-ABR" on a host computer.
Operate entering various commands from the terminal software.
IPADR: Configures an IP address and number of sub net mask bits in
command.
IPADR=192.168.209.10/24
* The number of mask bit can be omitted if you do not want to change the sub
net mask.
Enter "IPPORT =" command to configure a service port (for reading result
transmission) in TCP server connection.
Enter "IPPORT2 =" command to configure a service port (for image data
transmission) in TCP server connection. (Another port also can be specified.)
IPPORT=27110
IPPORT2=27110
Configure the default gateway address by the command below.
GWADR =192.168.209.254
*Set the same network as IP address.
Confirm the LAN settings by the command below.
?LAN
Save the settings to internal flash memory by the command below.
WSETS
* "Write OK" is sent when the settings are saved Write OK.
66