Mounting Your Tv To The Wall; Care And Cleaning - RCA L26WD26D User Manual

Other Information
L26WD26D base
L32WD26D base

Care and Cleaning

CAUTION: Turn OFF your TV/DVD before cleaning.
You can clean the TV/DVD as required, using a soft lint-free cloth. Be sure to occasionally dust the ventilation slots in
the cabinet to help assure adequate ventilation.
The TV/DVD's screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the
screen. If necessary, you may use a cloth dampened with warm water. Never use strong cleaning agents, such
as ammonia-based cleaners, or abrasive powder. These types of cleaners will damage the TV/DVD.
While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV/
DVD. Also, avoid placing drinks or vases with water on top of the TV/DVD. This could increase the risk of fi re or shock
hazard or damage to the TV/DVD.
Handling Cautions
• Before connecting other components to this TV/DVD, be sure to turn all components off.
• Don't move the TV/DVD while a disc is being played. The disc may get scratched or broken, and the TV/DVD's
internal parts may be damaged.
• Don't put any container fi lled with liquid or any small metal objects on the TV/DVD.
• Exterior infl uences such as lightning and static electricity can affect normal operation of this player. If this occurs,
turn the TV/DVD off and on again with the POWER button, or disconnect and then reconnect the AC power cord to
the AC power outlet. The TV/DVD will operate normally.
• Be sure to remove the disc and turn off the TV/DVD after use.
Formation of Condensation
• Due to sharp changes in temperature and humidity, condensation may form if warm air comes in contact with any
cold parts inside the TV/DVD. When condensation forms inside the TV/DVD, it may not operate correctly. If this oc-
curs, leave the TV/DVD at room temperature until the inside becomes dry and operational.
• If condensation forms on a disc, wipe the disc with a soft, dry cloth by moving the cloth from the center hole to-
ward the outer edge.
Handling Discs
• Don't touch the disc's signal surfaces. Hold by the edges or by one edge and the hole in the center.
• Don't affi x labels or adhesive tape to label surfaces. Don't scratch or damage the label.
• Do not use damaged (cracked or warped) discs.
40

Mounting Your TV to the Wall

Caution: The wall mount must bear a minimum of fi ve times
the TV's net weight without causing damage.
To mount your TV to the wall you need to purchase a VESA wall
mount. For model L26WD26D, purchase a VESA 100 x 100, M4; and
for model L32WD26D, purchase a VESA 200 x 200, M6 (100 x 100, for
example, means the mounting measurements are 100mm horizontally
and 100mm vertically; M4 is the type of screw that needs to be used).
1. You need to remove the base fi rst before attaching the wall mount.
A. Place the TV facedown on a surface that is soft, yet strong
enough to hold the TV.
B. Use a screwdriver to remove the screws (5 for model
L26WD26D; 4 for model L32WD26D) from the holes on the back
of the TV's base as the arrows indicate to the left.
2. Prior to hanging the TV on the wall, make sure all cables are
already connected to the TV since access to the jacks would be
diffi cult once it is hung.
3. Follow the directions included with the wall mount to mount the
TV to the wall.
Chapter 6