Chapter 1 I Connections And Setup; Before Initial Setup; Protect Against Power Surges; Safety Information - RCA L22HD41 User Manual

1 Connections and Setup

Before Initial Setup

Protect Against Power Surges

• Connect all components before you plug any power cords into the wall outlet or power strip.
• Turn off the TV before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions.

Safety Information

• Protect components from overheating.
• Don't block ventilation holes on any of the components. Arrange the components so that air can circulate freely.
• Don't stack components.
• If you place the component in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't harm

Avoid Audio Interference

• Position cables properly; insert each cable firmly into the designated jack.
• If you place components above the TV, route all cables down one side of the back of the TV instead of
• If your antenna uses 300-ohm twin lead cables, do not coil the cables.
• Keep twin lead cables away from audio/video cables.

Avoid Direct Light

Don't place the TV where sunlight or room lighting is directed toward the screen. Use soft or indirect lighting.

Check Supplied Parts

Check that the following parts were packed with your product.
Replacing your remote
If you need to replace
your remote, call
1-800-257-7946. A
shipping and handling
fee, and the appropriate
sales tax, will be charged
upon ordering. Please
have your Visa or
MasterCard ready.
6
Chapter 1 Connections and Setup
NEVER plug your TV into an outlet that is controlled by a wall switch.
other components.
straight down the middle.
RC246
REMOTE CONTROL
PART # RC2463001/01
ST-SCREW
2 AAA BATTERIES
only for models L22HD41
/L22HD41V
STAND CAP
POWER CORD
Graphics contained within this publication are presentation only.
only for models L26HD41/
L26HD31R
STAND CAP
CABLE MANAGE-
MENT STRAP