Amana CRC18T2OG Service Manual page 51

Programming
Memory Pads
From the factory, this oven can of store up to
10 cooking programs. Follow instructions
below to program cooking times and power
levels for customized cooking. Example:
Program third cooking sequence to heat for
30 seconds at 80% power.
1. Open oven door.
• Display shows "READY".
• If door is closed or RESET pad is
pressed before finishing programming
sequence, oven exits programming
mode.
2. Press and hold pad 1 for approximately
5 seconds.
• After 5 seconds, signal sounds.
Display shows "P:0".
3. Press 3 pad to select memory pad.
• Display shows cooking time, "COOK
LEVEL" and power level if other than
100 percent power.
4. Press 3 and 0 pad to enter desired
cooking time.
5. Press POWER LEVEL pad to change
power level.
• Display shows "COOK LEVEL" and
current power level if other than 100
percent power.
6. Press 8 pad to enter desired power level.
7. Press START pad to save new cooking time and
power level in oven memory.
• Display shows "P:0".
• Repeat step 3–8 to program additional pads.
8. Press STOP/RESET pad or close oven door to exit
programming mode.
Double Pad Programs
The oven control can be changed to store up to 100
cooking programs. See the "User's Options" section of
this manual to change oven control.
To create a double pad program, follow the
instructions above except for a change to
step #3. When entering the cooking
program number, press 2 memory pads.
For example, press pads 0 and pad 3 to
create a new cooking program.
RS2240002 Rev. 0
Multiple Cooking Stages
Follow instructions below to program oven
to perform four consecutive cooking cycles
without interruption. Example: Program
third cooking sequence to heat for 30
seconds at 80% power, 40 seconds at
50% power, and 10 seconds at 100%
power.
1. Open oven door.
• Display shows "READY".
• If door is closed or RESET pad is
pressed before finishing programming
sequence, oven exits programming
mode.
2. Press pad 1 for approximately 5
seconds.
• After 5 seconds, signal sounds.
Display shows "P:0".
4. Press 3 pad to select memory pad.
• Display shows cooking time, "COOK
LEVEL" and power level if other than
100 percent power.
5. Press 3 and 0 to enter desired cooking
time.
6. Press POWER LEVEL pad to change
power level.
• Display shows "COOK LEVEL" and
current power level if other than 100
percent power.
7. Press 8 pad to enter desired power
level.
8. Press TIME ENTRY pad.
• Display briefly shows "P:03
indicating programming, pad 3, stage
2. Then cook time and power level for
stage show in display.
• Repeat steps 5–8 to create
additional stages.
9. Press START pad to save new cooking
time and power level in oven memory.
10. Press STOP/RESET pad or close oven
door to exit programming mode.
A–16
(1-4)
"