Wiring The Fault Alarm Contact - B&B Electronics Elinx EIR418-2SFP-T User Manual

2. Tighten the wire-clamp screws for prevent the wires from becoming loose.

Wiring the Fault Alarm Contact

The fault alarm contact is in the middle of the terminal block connector as shown below.
If one of the power sources fails a fault will be detected causing the circuit to open.
Note The wire gauge for the terminal block should be 12 to 24 AWG.
13
Insert the wires into the fault alarm contact (No. 3 & 4)
Manual Documentation Number EIR418-2SFP-T – 0109m
Hardware Description
www.bb-elec.com
www.bb-europe.com