Graco Husky 716 Instructions-Parts List Manual

Graco Husky 716 Instructions-Parts List Manual

Texture pump 100 psi (0.7 mpa, 7 bar) maximum air and fluid working pressure
Hide thumbs Also See for Husky 716:

Advertisement

INSTRUCTIONS-PARTS LIST
This manual contains important
warnings and information.
READ AND KEEP FOR REFERENCE.
INSTRUCTIONS
Huskyt 716 Texture Pump
100 psi (0.7 MPa, 7 bar) Maximum Air and Fluid Working Pressure
Model 239753, Series A

Table of Contents

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
2
4
4
5
6
7
8
10
11
13
14
14
ECOPYRIGHT 1999, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
Parts
309009
Rev. C
9306A

Advertisement

Table of Contents
loading

Summary of Contents for Graco Husky 716

  • Page 1: Table Of Contents

    ......9306A GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441 ECOPYRIGHT 1999, GRACO INC. Graco Inc. is registered to I.S. EN ISO 9001...
  • Page 2: Warnings

    D Read all instruction manuals, tags, and labels before you operate this equipment. D Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor. D Do not expose the system to rain. Always store the system indoors.
  • Page 3 WARNING TOXIC FLUID HAZARD Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin, inhaled, or swallowed. D Know the specific hazards of the fluid you are using. D Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local, state, and national guidelines.
  • Page 4: Operation

    Operation See your system manual for operating instructions. Maintenance Threaded Connections WARNING Every six months of use, remove the pump from the cart, and thoroughly check and tighten all threaded PRESSURIZED EQUIPMENT HAZARD connections. The equipment stays pressurized until pressure is manually relieved.
  • Page 5: Troubleshooting

    Troubleshooting See the Troubleshooting section of instruction See Pressure Relief manual 308718 before you proceed with the table Procedure on page 4. below. Check all possible problems and causes before you disassemble the pump. PROBLEM CAUSE SOLUTION Pump will not cycle, or cycles once Air valve is stuck or dirty.
  • Page 6: Service Air Valve

    Service — Air Valve Air Valve Repair Kit 241657 is available. Parts included in the kit are marked with a dagger ({) in Fig. 2 and in the Parts Drawing and Parts List on pages 10 and 11. A tube of general purpose grease 111920 is supplied in the kit. Service the air valve as follows.
  • Page 7: Duckbill Valves

    Service — Duckbill Valves Duckbill Valve Repair Kit 239754 is available. Parts included in the kit are marked with a double dagger (}) in Fig. 3 and in the Parts Drawing and Parts List on pages 10 and 11. Service duckbill valves as follows. See Fig. 3. Disassembly Relieve the pressure.
  • Page 8: Diaphragms

    Service — Diaphragms Fluid Section Repair Kit D05007 is available. Parts included in the kit are marked with a star (L) in Fig. 4 and in the Parts Drawing and Parts List on pages 10 and 11. General-purpose grease 111920 and Adhesive 113500 are supplied in the kit.
  • Page 9 Service — Diaphragms Included in Fluid Section Repair Kit D05007 Install with lips facing out of center housing (3). Torque to 40 to 50 in-lb (4.5 to 5.6 N-m). Apply grease. The words AIR SIDE on diaphragm (36) must face toward diaphragm shaft (74).
  • Page 10: Parts Drawing

    Parts Drawing Texture Pump, Model 239753, Series A { Included in Air Valve Repair Kit 241657, which may be purchased separately. } Included in Duckbill Valve Repair Kit 239754, which may be purchased separately. L Included in Fluid Section Repair Kit D05007, which may be purchased separately.
  • Page 11: Parts List

    Parts List Texture Pump, Model 239753, Series A Ref. Part Ref. Part Description Description 185622 COVER, fluid; aluminum 112914 WASHER, flat; 3/8”; sst 185624 MANIFOLD; aluminum; npt 290045 PLATE, designation 192602 HOUSING, center 113341 SCREW, torx 110782 O-RING; buna–N 194246 COVER air 192138 SPACER;...
  • Page 12 Notes 309009...
  • Page 13: Technical Data

    Technical Data Technical Data based on tests with water. Data varies with different materials and operating conditions. Maximum air and fluid working pressure ..........100 psi (0.7 MPa, 7 bar) Air pressure operating range .
  • Page 14: Graco Warranty

    Graco distributor to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.

This manual is also suitable for:

239753

Table of Contents