Receiving; D Receiving An Individual Selcall; D Recalling A Memorised Rx Code; D Receiving A Group Call - Icom IC-41PRO Advanced Manual

6
SELCALL (Selective Calling)

Receiving

D Receiving an individual Selcall

q When receiving an RX code:
• Beeps sound.
• The RX code's text is displayed, if entered.
• "ë" blinks and the channel name is displayed, and the
Selcall mute is released.
w Hold down [PTT] and speak at your normal voice
level.
Blink
NOTE:
• If the ID decode function "ID Dec" is turned ON, the
received Own ID code is displayed instead of the text,
and memorised into the transceiver. This function can
be turned ON using the CS-41PRO
• A maximum of 8 individual RX codes can be memorised
into the transceiver, using the CS-41PRO
.
sOftware

D Recalling a memorised RX code

q Push [TOP] to enter the Function mode, and then
hold down for 2 seconds to display the memorised
RX code.
w Rotate [ROTARY SELECTOR] to select the desired
RX code.
e Hold down [PTT] to transmit to the selected code.
NOTE: When a 6th RX code is received, the oldest
code is deleted from the transceiver.

D Receiving a Group call

q When receiving a Group call:
• Beeps sound.
• "ë" and "GROUP" blink, and the Selcall mute is
released.
w Hold down [PTT] and speak at your normal voice
level.
Blink
• You can set the Group call receiving options using
the optional CS-41PRO
the CS-41PRO help file for more information.
clOning sOftware
clOning
. Consult
clOning sOftware

Quiet Mode

When the Quiet mode is ON, the Selcall mute function
is activated and enables silent operation until a Selcall
code is received.
q Push [TOP] to enter the Function mode.
w Push to turn the Quiet mode ON or OFF.
• "Q" is displayed when the Quiet mode is ON.
To monitor the channel:
➥ Push [Side 1] to release the
mute.
• A beep sounds.
To enable the Selcall mute:
➥ Push [Side 1] to enable the
mute.
• A beep sounds.
NOTE: The unmute mode may automatically return
to the mute mode after a specified time period,
depending on the presetting.
.

Stun function

This function can only be set by your dealer. If the
transceiver is in the Stun mode, it will request a
password when you turn ON the transceiver. This
password is the same as the Power ON password.
Once the password has been entered, the transceiver
will not prompt you to enter it again.
Cloning and transceiver operations are disabled
after a Kill ID is received. By activating the clone write
mode, you can use the transceiver again. (The
internal data cannot be accessed using the Clone
Read mode.)
14