Connecting A Display Unit - Omron 3F88L-160 User Manual

Design
H Cam Output Specifications
Item
Maximum switching capacity
Leakage current
Residual voltage
ON response time
Off response time
Internal circuit

2-3-6 Connecting a Display Unit

If the Cam Positioner is connected to a Display Unit, the present angle and Resolver
speed can be displayed.
The Display Unit is connected to the cam output connectors on the Unit via Cam Output
Cables.
Note 1. The speed display can have an error margin or 5 r/min max.
Note 2. Parameters must be set to display present values such as the present angle
and Resolver speed. The present value output and cam output share termi-
nals. Some cam output signals can no longer be used, therefore, when pres-
ent values are being output.
H Connecting a M7E Display Unit
Use a 3F88L-CGjjjS Cam Output Cable to connect the M7E Display Unit.
3F88L-160/162 Cam Positioner
D Functions
The present angle (in degrees) or the Resolver speed (r/min) can be displayed on a 3- or 4-digit Display
Unit. The display data is set using the present value display function parameters.
24 V DC –15%/10%, 0.3 A/point, 1.6 A/connector
0.1 mA max.
1.5 V max.
0.05 ms max.
0.07 ms max.
3F88L-CGjjjS Cam Output Cable
Specifications
CAM1 to 32
M7E Display Unit
Chapter 2
2-25