Table of Contents
Advertisement
4012-0XX
14. A latch on the top front end of each side frame holds the trans-
port motor frame in place. Push up the latches on the front of the
side frames, then pivot the carrier transport motor frame down
and out of the side frames.
15. Place the machine on its back, then unlatch the right frame latch
from the middle frame and remove the side frame.
Note: For reassembly you may want to remove the carrier guide
and reinstall it after you install the paper guide.
When you reinstall the paper guide, be sure the front edge goes
under the rear of the carrier guide. If the paper guide is on top of the
carrier guide, push down the front bottom edge. It will snap under the
carrier guide.
To install the right side frame onto the middle frame, align the right
side frame latch with the latching surface on the mid frame before
you align the roller shafts and carrier guide. It may be easier to do
this with the machine on its left side.
Repair Information
46
Advertisement
Table of Contents
