Covers Removal; Front Cover; Rear Cover; Top Cover - Lexmark Medley 4012-009 Service Manual

4012-0XX

Covers Removal

Front Cover

1. Remove the left and right side covers.
2. Flex the front cover to release the latches on each end.
3. Lift the cover to free the lower latch and remove the cover.
Note: When reinstalling the front cover, make sure the lower latch
and side latches are installed properly to prevent the cover from
interfering with the paper ejectors.

Rear Cover

1. Remove the left and right side covers.
2. Flex the tabs on the subframe to release both latches.
3. Lift the cover to free the lower latch and remove the cover.

Top Cover

1. Bend the subframe slightly to free the top cover pivot pin.
2. Remove the top cover.

Right Side Cover

1. Remove the paper load lever.
2. Open the operator panel cover and the top cover.
3. Remove the screw from inside the subframe just above scanner.
4. Lift on the top inner edge of the cover to free the top latches.
5. Rotate the cover to the right to free the lower latches.

Left Side Cover

1. Open the operator panel cover and the top cover.
2. Remove the screw from inside the subframe just above scanner.
3. Lift the top inner edge of cover to free the top latches.
4. Rotate the cover to the left to free the lower latches.
5. If the battery option is installed, disconnect its cable from the fax
board (J9).

Operator Panel and Cover

1. Remove the left and right side covers.
2. Flex the subframe to free one of the pivot pins.
3. Remove the two screws and the ESD shield.
4. Disconnect the operator panel cable from the back of the opera-
tor panel.
5. Unsnap the operator panel from the cover.
Repair Information
34