Terminal Blocks - ABB ACS800-07-0610-3 Hardware Manual

30

Terminal blocks

X500
X2
1
2
X3
1
2
3
X4
1
2
3
X5
X6, X7
X8
X9
1
2
3
4
5
6
X10
Hardware description
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Ribbon cable to DSCB board via module quick connector
Measurement for actual value display (factory-wired)
DC+ Intermediate circuit voltage (+ and - busbars)
DC-
Measurement for actual value display (factory-wired)
U Phase voltage
V Phase voltage
W Phase voltage
24 V (or 48 V) output, short-circuit protected, live when AC power input of DSU is live
-24V Power supply output: +24 VDC / max. 3 A and -24 VDC / max. 0.5 A (or
48 VDC / max 0.5 A)
+24V
Note: Terminals can also be used to supply DSU control boards externally
Ground
during input power break. Use two 24 V / 1 A floating power supplies.
Connect between +24V & Ground and Ground & -24V.
Remote digital inputs
See Digital input and relay output terminals
Relay outputs
See Digital input and relay output terminals
Emergency stop input
See Emergency stop input
Phase current output for an external display device (e.g. a meter on the cabinet door).
For scaling, see Reading and setting of values (page 2 of 2)
meters. Connect the meter between the current output terminal and ground (cabinet frame).
Type tested and used by ABB: BQ307 by Iskra (www.iskra-mis.si).
U1.1 Phase current value as a 0...1 mA signal (= 0...nominal DSU current)
V1.1 Phase current value as a 0...1 mA signal (= 0...nominal DSU current)
W1.1 Phase current value as a 0...1 mA signal (= 0...nominal DSU current)
U1.2 Phase current value as a 0...1 mA signal (= 0...nominal DSU current)
V1.2 Phase current value as a 0...1 mA signal (= 0...nominal DSU current)
W1.2 Phase current value as a 0...1 mA signal (= 0...nominal DSU current)
Local digital inputs
See Digital input and relay output terminals
on page 31.
on page 31.
on page 32.
on page 31.
on page 29. Use single phase