Table of Contents
Advertisement
Model CC639 Only: Remote Control
Model CC639 Only: Lithium Cell Installation
The remote's lithium cell is packed separately. Install it as follows:
Insert Pencil Here
Lithium Cell
1. Turn remote over, insert a pencil or
paper clip in the small hole, and slide
it in the direction of the arrow while
removing the holder.
2. Insert the lithium cell into the holder
with its positive (+) terminal facing up.
3. Slide the cell in the holder back into
the remote until it clicks into place.
Remote Sensor
The remote operates the camcorder by infrared light, so it is protected from electrical
and sound interference. However, the remote must be aimed directly at the
camcorder's remote sensor. There cannot be any obstructions between them.
Remote Control Sensor
Notes: The camcorder may not respond to
the remote if its sensor is exposed to direct
sunlight or strong artificial light.
Back of
Remote Control
Belt Clip
Holder
Cautions:
Lithium cell battery. Replace
only with 3-volt lithium cell – such as CR2025.
Use of other cell presents a risk of fire or
explosion. Must be disposed of properly.
Never handle punctured or leaking cell. May
cause burns or personal injury.
Keep out of the hands of children. Can cause
death or injury if swallowed. If swallowed,
consult a physician immediately for emergency
treatment.
The lithium cell used in this device may explode
resulting in a fire or chemical burn if mistreated.
Do not recharge, disassemble, heat above 212˚F
(100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and
never short circuit the + and – sides of the cell.
Notes: Never place anything heavy on top of
the remote or lay it upside-down. This may
accidentally depress the buttons for a long
time and discharge the lithium cell.
Replace the cell when the camcorder fails to
respond to the remote.
Remove the cell from the remote if it will not
be used for a month or more. This will
prevent possible damage from cell leakage. If
leakage occurs, wipe up the liquid inside the
compartment and replace the cell.
You can program the remote to also operate a
compatible VCR while copying or editing
tapes. Details are on pages 86-87.
17
Advertisement
Table of Contents
