Install Lithium Cell - RCA PROV600 User Manual

Install Remote's Lithium Cell
The remote's lithium cell is packed
separately. Install it in the remote as
follows:
1. Turn the remote over, insert a pencil or
paper clip in the small hole, and slide
the cell holder in the direction of the
arrow to remove it.
2. Insert the cell in the cell holder so the
positive (+) terminal faces up.
3. Replace the cell holder in remote by
pressing in until it clicks into place.
Notes: Never place anything heavy on top of
the remote control or lay it upside-down.
Replace cell when camcorder fails to respond
to remote.
Remove cell from remote if it will not be used
for a month or more. This will prevent
possible damage from cell leakage. If leakage
occurs, wipe up liquid inside compartment and
replace cell.
Caut ons, L_thmm:.cell mustbe • :,,::::: :_:.: :. :
dispos_ :of proper!y!iiiN_r handle :_ii: :::::
pm]ctured 0r::leak_gi_¢ellili::May ca_e i::::!_ ::
bums or personai ifijU_:. : ::: : :ii : :_ii): ::_!,i_ i.
Keep out: of._he hanoi 6f _hildren.::):_i__i::: :ii
Can cause: death or mj_:: ff :
swallowed: :if.s_ailow_i _onsulta::::. :_iii::i: (
physician :immediat_|ylfor:emerg_nc_
treatmentl : :::i; .: :: :.._::::;:: .:
The lithium cell used::in.this device:::
may.e resulting in a fire or: :;:/::::::::::::: :::::
chemical bum if mistreated. Do not
recharge;disassembleifieat:above :_:' !::): :: _i:_ ::
Never use metallictweezers .to hold:-::_ :
the cells, and never gho_circuit the:+
and - sides of the celk
15