Follett 7UC100A Installation, Operation And Service Manual page 7

Installation
(continued)
2 . Ensure that the finished floor inside the cabinet is flush (level) with
the floor outside the cabinet (Fig . 2) . If the cabinet floor is lower
than the finished floor, the cabinet floor must be built up (using
appropriate materials) until it is flush with the finished floor . A flush
floor is required for proper operation and maintenance/service of the
dispenser .
3 . Rough-in the electrical service, water line, and optional Drip Tray
Drain Kit* .
Note: The dispenser must be installed such that it can be moved
forward at least 4" (102 mm) to allow access to the Bin Lid
Cleaning Spout for dispenser cleaning and sanitizing . Take this
requirement into consideration during rough-in .
§ Electrical: 115V, single phase, 15A receptacle required . The dispenser
has an integral 8 ft . (2 .4 m) cord and plug .
§ Water: supply line (with shut-off valve) connects to the dispenser's 1/4"
MPT inlet .
* The optional Drip Tray Drain Kit (item# 00956375) requires a floor drain
within 15 ft . (4 .5 m) of the dispenser . For detailed installation instructions,
please refer to the instructions shipped with the Drip Tray Drain Kit .
4 . Install the angle bracket inside the cabinet,18 .15" (461 mm) from
the toe kick (Fig . 3 .1) . The bracket prevents the dispenser from
being located/pushed beyond the recommended cabinet space
depth . Do not attach the bracket to the dispenser .
5 . Connect the water line . Connect power supply .
6 . Sanitize the dispenser prior to use (see Cleaning and Sanitizing on
page 10) .
–––––––––––––––––––––––––––––––––––––––––––––––––
Undercounter Dispenser and Icemaker 7UC100A/7UD100A
Fig . 2
cabinet space
floor
Fig . 3
1
18.15" (461 mm)
7