Inserting Compactflash Cards - Raymarine C-Series Operating Manual

Getting Started

Inserting CompactFlash cards

Card No. 3
CAUTION
CompactFlash Card Installation
When installing CompactFlash cards ensure that the card is being fitted the correct
way around.
DO NOT try and force the card as this may result in irreparable damage to the
card.
Water Ingress
To prevent the ingress of water and consequent damage to the display, ensure
that the chart card door is firmly closed at all times during operation. This can be
confirmed by an audible click.
Card Removal
DO NOT use a metallic instrument such as a screwdrver or pliers to help you
remove a card, as doing this can cause irreparable damage.
Card Writing
CompactFlash cards can be damaged if they are removed during either a read or
write operation. A warning is displayed during write operations. The unit is
continually reading the card. It is therefore essential that before removing the
card you follow the correct procedure.
How do I insert a CompactFlash card?
Narrow
Groove
Lip
?
More information.....
For more information on using CompactFlash cards refer to Chapter 2 - General Operation &
Sysstem Set Up of the C-Series Reference Manual.
Page 5 of 18
To insert a card, refer to the illustration, and:
1. Check that you are using the correct type of
card. Raymarine recommend Navionics Chart
cards or SAN DISK CompactFlash cards.
2. Open the chart card door, located on the front
left of the display.
3. Insert the card as shown, with the lip of the
card facing inwards, it should position easily. If
it does not, DO NOT force it, check the direction
in which the lip is facing.
4. Gently press the card home.
5. To prevent the ingress of water and consequent
damage,close the chart card door and press
firmly until a click is heard.