Lennox T7300 Installation Instructions Manual page 10

Installer
Installer
Setup
Setup Name
Number
Heat Pump
0360 Auxiliary Lock-
out
Temporary Oc-
0535 cupied Duration
Limit
Number of Pe-
0540
riods
Minimum Com-
pressor Off
0580
Time
Heat Tempera-
0600 ture Range
Stops
Cool Tempera-
0610 ture Range
Stops
0640 Clock Format
Extended Fan−
0650
on time Heat
Extended Fan−
0660
on time Cool
Keypad Lock-
0670
out
Temperature
0680
Control Heat
Table 3 − Installer Setup Menu (Continued)
Default
All Settings
Setting
0− None
40(4.5)−40°F(4.5°C)
45(7.0)−45°F(7.0°C)
0
50(10.0)−50°F(10.0°C)
55(13.0)−55°F(13.0°C)
60(15.5)−60°F(15.5°C)
0−None
1−one hour
3 2−two hours
3−three hours
4− four hours
2− 2 Periods
4
4− 4 Periods
0− Off
2− 2 minutes
0 3− 3 minutes
4− 4 minutes
5− 5 minutes
90 40 to 90° F (4 to 32° C)
50 50 to 99°F (10 to 37°C)
12−12 Hour 24− 24
12
Hour
0−Off
0
90− 90 seconds
0−Off
0
40− 40 seconds
0−Unlocked
1−Partial Lockout 1
0
2−Partial Lockout 2
3−Fully Locked
1−Less Aggressive
2 2−Standard
3−More Aggressive
Lennox commercial equipment does not use
heat pump mode. Only shown for heat pump
systems with more heat stages than cool se-
lected and remote sensor selection is outdoor
for control. Must enforce a dead band between
this and Heat Pump Compressor Lockout.
0 means no limit
Does not appear if Non− programmable is cho-
sen. Applies to all days of the week. With 2 se-
lected the Cancel Period option does not ap-
pear on the display.
Only shown if system has cool stages. Set to 0.
Not needed for 3 phase systems.
Only shown if system has heat stages.
Only shown if system has cool stages.
Not displayed with fan set to fossil or with cool−
only systems.
Only shown if system has cool stages.
Unlocked: All functions accessible.
Partial 1: Locks all but Holiday, Override, and
Up/Down.
Partial 2: Locks all but Holiday and Override.
Full: Entire interface locked/non−functional.
Only shown if system has heat stages.
Only integral gains affected. Affects control op-
eration in all control regimes (not just recovery
or setpoint change).
More Aggressive stops signal prior to reaching
the setpoint. (For use with oversized equip-
ment.)
Page 10
Notes