If You Have Problems; Manual Code Search - Radio Shack 4-in-One Smart Light-Up Remote Control Owner's Manual

15-1993.fm Page 14 Wednesday, October 20, 1999 12:03 PM

IF YOU HAVE PROBLEMS

MANUAL CODE SEARCH

If the 4-in-One Smart Light-Up Remote Control
does not operate your remote-controlled devic-
es when you first set it up, you might have to
manually find the correct codes for your devic-
es. You can try all the codes listed in "Manu-
facturer Codes" on Page 17 for your brand
device, or you can follow these steps to search
the remote control's entire library.
1. Manually turn on the device you want to
set up.
2. Press the corresponding device key (
, , or ).
VCR CBL AUX
3. Hold down until the red light blinks twice,
P
then press . The red light blinks twice
9 9 1
again.
4. Aim the remote control at the device you
want to operate.
5. Repeatedly press
POWER
key ( , , , or
TV VCR CBL
turns off.
6. When the device turns off, press
10 seconds to save the code. The red light
blinks twice.
Note: If you do not press
onds, the remote control does not save the
code.
• Because the 4-in-One's library has so
many codes, this can take several min-
utes.
• If your device turns off during the
search, but does not operate after you
lock in the code, begin the search
again, pausing longer between key
presses.
14
,
TV
then the device
) until the device
AUX
within
P
within 10 sec-
P