Radio Shack 4-in-One Smart Light-Up Remote Control Owner's Manual page 9

15-1993.fm Page 9 Wednesday, October 20, 1999 12:03 PM
1. Place your original remote control nose-to-
nose with the RadioShack Smart Light-Up
Remote Control.
2. Hold down until the red light blinks twice,
P
then press . The red light blinks twice
9 7 5
again.
3. Press the device key (
) for the mode where you want the
AUX
function to reside.
Note: You can program each smart key for
a different function in each of the four
modes. For example,
MENU key in TV mode and a TRACKING
key in VCR mode.
4. Press one of the smart keys. The red light
blinks rapidly.
5. Hold down the key that you want to copy
on your original remote until the red light
on the 4-in-One Smart Light-Up blinks
twice.
6. Hold down until the red light blinks twice.
P
7. Press the smart key you programmed. The
key should control the same function as
the key that you copied from your original
remote.
8. Repeat Steps 1–7 to program other smart
keys.
, , , or
TV VCR CBL
might serve as a
1s
9