Adjusting Sound; Setting Up The Remote - Radio Shack 15-2107 Owner's Manual

8. To save the settings, hold down
9;II 9;II ;N?J?D= ;N?J?D=
9;II 9;II ;N?J?D= ;N?J?D=
appears.
screen.

ADJUSTING SOUND

Your remote has three alert beep tones.
Tone
One low tone Valid key press or touch
One high tone Invalid key press or touch
Double low tone Valid mode key touch
Sound is preset to On. Follow these steps to turn sound
off or on.
1. Hold down for at least 3 seconds.
P
appears.
Note: To exit setup, hold down
;N?J?D= ;N?J?D=
;N?J?D= ;N?J?D=
onds. appears, then the last-used mode
screen.
2. Touch the up arrow.
Note: If you scroll past
to return to it.
ED ED ED ED
3. Touch .
SELECT
Note: If you change your mind, touch the up or
down arrows until you see
Step 4.
IK99;II IK99;II
IK99;II IK99;II
4. Touch .
SELECT
the last-used mode screen.

SETTING UP THE REMOTE

Note: If no key is pressed for 60 seconds, the remote
control automatically exits setup.
the remote returns to the previous mode screen.
1. Find the codes for your device(s) in "Manufacturers'
Codes" on Page 47. On the supplied label, write
SELECT
appears, then the last-used
Type of Alert
for at least 3 sec-
P
IEKD: IEKD:
IEKD: IEKD:
appears.
IEKD: IEKD:
IEKD: IEKD:
, touch the down arrow
E E E E << << << <<
or appears.
ED ED ED ED
, then continue with
appears, then
;N?J?D= ;N?J?D= ;N?J?D= ;N?J?D=
appears, and
Preparation
IK9# IK9#
IK9# IK9#
until
9E:;ý I;J 9E:;ý I;J
9E:;ý I;J 9E:;ý I;J
;N?J?D= ;N?J?D=
;N?J?D= ;N?J?D=
, then
23