Onkyo TX-NR929 Service Manual page 16

OPERATION CHECK-5
2.CONFIRMATIONS OF OPERATIONS
2-18. CONFIRMATION OF ETHER CONTROL./RS-232C
1. PC and the RS-232C terminal are connected.
2. Confirm the RS-232C operation by using the E-Control Check Tool
2-19. CONFIRMATION OF I/O OPERATION.
a. Confirm all input and output terminals operate normally.
b. Confirm the output by using a specified JIG or special player for DSD .
c. When use TEST MODE for DSD , "TEST 6-04" is confirmed to be output from FL,FR,C,SW,SL,SR and not to be output SBL,SBR.
2-20. CONFIRMATION OF Wi-Fi CONNECTION
1. After setting wifi routers, change the state to "IDLING TIMER MODE".
2. It connects an access point automatically. Wi-Fi LED flashes during connection.
3. When connection is completed and IP address is able to be acquired, Wi-Fi LED lights up and the value of RSSI to an access point
is displayed per dbm.
If the connection failed, NG is displayed.
SSID No
If the connection failed, exit the idle mode by pressing the TV/CD button and please try again from [a].
*When check DHC-60.5,it is also same as TX-NR929,DTR-60.5.
Please be as NG if FL display doesn't even after 4 minutes in idling mode.
2-21. CONFIRMATION OF HD BASE-T.(ONLY DTR-60.5 (EXCEPT MJJ /DHC-60.5)
1. AVR and the HD BASE-T RX BOX are connected with ETHERNET cable.
2. HD BASE-T RX BOX and TV are connected with HDMI cable.
3. Confirm the VIDEO FUNCTION CHECK of page10
You must use ethernet cable more than CAT5.
1 -45d 00:10:00
RSSI(dbm) Time Counter
TX-NR929/ DTR-60.5/ DHC-60.5