Fr Traffic-Shaping - HP A8800 Series Command Reference Manual

Instead of removing an FR class, the undo fr-class command just cancels the association between the FR
class and the current FR PVC. To remove an FR class, use the undo fr class command.
Related commands: fr class.
Examples
# Associate FR class test1 with an FR PVC with DLCI 200.
<Sysname> system-view
[Sysname] interface Serial 2/1/6:0
[Sysname-Serial2/1/6:0] fr dlci 200
[Sysname-fr-dlci-Serial12/1/6:0-200] fr-class test1

fr traffic-shaping

Syntax
fr traffic-shaping
undo fr traffic-shaping
View
FR interface view, MFR interface view
Default level
2: System level
Parameters
None
Description
Use fr traffic-shaping to enable FRTS.
Use undo fr traffic-shaping to disable FRTS.
By default, FRTS is disabled.
FRTS is applied to the outgoing interfaces and are usually applied to the DCE of an FR network.
Related commands: fr class and fr-class; fr dlci (Layer 2—WAN Command Reference).
Examples
# Enable FRTS on Serial 2/1/6:0.
<Sysname> system-view
[Sysname] interface Serial 2/1/6:0
[Sysname-Serial 2/1/6:0] fr traffic-shaping
117