Installation - Axis T95A00 Installation Manual

AXIS T95A00/T95A10 Dome Housing
Tools/ Parts not included
Phillips screw driver
Ceiling bracket for AXIS 231D+/232D+ (supplied with the network camera)
Adjustable wrench
Other required parts
Mounting bracket
Power cable
Network cable
Soft cloth
Note:
Not all screws provided are required for all camera installations.

Installation

Follow these steps indoors before the installation outdoor to save time at the installation site.
Top cover
Attach Universal Adaptor to camera
1. Remove the top cover of the housing (with four screws) from the housing using the 3mm allen
key.
2. For AXIS T95A00 Dome Housing only - remove the two connectors (with black and blue cables)
attached to the circuit board on top of the Universal Adapter.
3. Loosen the three screws holding the Universal Adaptor. Rotate slightly and remove the
Universal Adaptor from the housing.
4. Attach the Universal Adaptor to the camera. For details see page 14.
Note:
Do not install the camera in the housing at this point. Transport it carefully to the place of
installation first.
See www.axis.com for available brackets and accessories
Examples:
AWG20, 100-240 VAC cable (AXIS T95A00 Dome Housing)
AWG22, 24 VAC cable (AXIS T95A10 Dome Housing)
CAT 5 shielded twisted pair (STP) cable recommended
Recommended for protecting the dome while installing the housing
Blue cable
Black cable
Page 5
Universal Adaptor