Document ID: 2098094
|
2009 Chevrolet Aveo
Aveo, Wave, G3, Barina (VIN S/T) Service Manual
Air Cleaner Inlet Duct Replacement
Removal Procedure
Note: The intake air temperature sensor is no longer replaced as a separate service item. If
the intake air temperature sensor is faulty, replacement of the entire air cleaner inlet duct
will be necessary.
1. Turn OFF the ignition.
2. Disconnect the electrical connector from the intake air temperature (IAT) sensor.
3. Disconnect the breather tube from the air cleaner intake duct.
4. Loosen the clamps securing the air cleaner intake duct.
5. Remove air cleaner intake duct.
Installation Procedure
http://localhost:9001/si/showDoc.do?docSyskey=2098094&pubCellSyskey=139186&pubO...
|
| Document ID: 2098094
Repair Instructions
© 2010 General Motors Corporation. All rights reserved.
|
|
Engine
Engine Controls and Fuel - 1.6L (LXT)
Page 1 of 2
7/5/2010