Troubleshooting - Radio Shack 32-2001 Owner's Manual

20-watt pa amplifier
Table of Contents

Advertisement

32-2001.fm Page 12 Friday, February 4, 2000 7:53 AM
ˆ Troubleshooting
If you should run into difficulties, check
the wiring of the system. Are there any
short circuits in the speaker wiring?
Have you provided adequate ventila-
tion? Did you calculate speaker imped-
ance correctly?
Be sure microphones and connecting
cables are not defective.
Be sure you are using large enough
speaker wire. You should always use
16-gauge (or larger) wire. The longer the
run of speaker wire, the heavier the
gauge should be.
If you have feedback problems, reposi-
tion your microphones and speakers, or
adjust
or
to a
TONE
MASTER VOLUME
lower setting.
If the amplifier does not work at all,
check the fuse on the rear panel. If it is
blown, replace it with one of the same
size and type (see "Replacing Fuses" on
Page 13).
If you are operating the unit from a 12-
volt DC power source, check the fuse in
the supplied cable that connects to your
vehicle's 12-volt accessory socket. If the
fuse is blown, replace it with a 4-amp
125-volt fuse (see "Replacing Fuses" on
Page 13).
If you cannot solve the problem, contact
your local RadioShack store for assis-
tance.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

811081640bMpa-40

Table of Contents