Configure Gas Standard Volume Flow Measurement Unit - Emerson Micro Motion 5700 Configuration And Use Manual

Procedure
Set Standard Gas Density to the density of your gas at reference temperature and
reference pressure.
You can use any reference temperature and reference pressure that you choose. It is not
necessary to configure these values in the transmitter.
Tip
ProLink III provides a guided method that you can use to calculate the standard density of your gas, if
you do not know it.
4.4.3

Configure Gas Standard Volume Flow Measurement Unit

Display
ProLink III
Web browser
Overview
Gas Standard Volume Flow Measurement Unit specifies the unit of measure that will be
used for the gas standard volume (GSV) flow rate. The unit used for gas standard volume
total and gas standard volume inventory is derived from this unit.
Prerequisites
Before you configure Gas Standard Volume Flow Measurement Unit, be sure that Volume
Flow Type is set to Gas Standard Volume.
Procedure
Set Gas Standard Volume Flow Measurement Unit to the unit you want to use.
• Default: SCFM (Standard Cubic Feet per Minute)
Tip
If the measurement unit you want to use is not available, you can define a special measurement unit.
Options for Gas Standard Volume Flow Measurement Unit
The transmitter provides a standard set of measurement units for Gas Standard Volume
Flow Measurement Unit, plus one user-defined special measurement unit. Different
communications tools may use different labels for the units.
Configuration and Use Manual
Menu > Configuration > Process Measurement > Flow Variables > Volume Flow Settings >
Units
Device Tools > Configuration > Process Measurement > Flow > Gas Standard Volume
Flow Unit
Configuration > Process Measurement > Flow Variables > Gas Standard Volume Flow
Unit
Configure process measurement
43