On-Air Programming - Radio Shack PRO-99 Owner's Manual

Ô
NOTES
• The scanner receives
only the data shown
above during on-air
programming.
• On air programming
data is normally
transmitted at the
race track during
races.
Invalid Freq.
•
Invalid Ch
appears if
the scanner receives
a channel number
equal to 0 or
frequency data which
is out of the range of
frequencies the
scanner can receive.
Checksum Error
•
appears if the
scanner receives a
checksum error.
58
ON-AIR
PROGRAMMING
You can also program your
scanner by receiving data
transmitted on a frequency your
scanner can receive (called on-air
Ô
programming).
You can use on-air programming
to store the following data into the
scanner:
or
4. Press to send the data to
1
the other unit, or press any
other key to cancel the
operation.
5. The scanner sends the data.
Do not disconnect the PC/IF
cable or interrupt power to
either scanner while the
transfer is taking place.
6. To exit the clone mode,
remove the cable.
• Channel number (from 000 to
949)
• Frequency (any frequency the
scanner can receive)
• Car number (from 0 to 999,
including 00, 000, 01, and
001)
• Channel text tag
• Channel lockout setting (ON
or OFF)
• Channel delay setting (ON or
OFF)
• CTCSS code (67 Hz – 250.3
Hz)
• CTCSS setting (ON or OFF)