Toyota 4A-FE Repair Manual page 72

EM-88
' -
ENGINE MECHANICAL - Cylinder Head (4A-FE)
EM749B
(6-
/
(_ )
/
/
EM7 305
EM703B
(b) Connect the water by-pass hose to the air pipe.
(c) Install the manifold stay with the bolt and nut.
Torque: 195 kg-cm (14 ft-lb, 19 N·m)
16. (4WD)
17. INSTALL ENGINE WIRE TO INTAKE MANIFOLD
(a)
Install the engine wire with the three bolts .
(b) Install the engine wire the engine to vacuum pipe with
the wire clamp.
{c)
Connect the following connectors:
• Throttle position sensor connector
• ISC valve connector
• (2WD w/ EGR system)
EGR VSV connector
• Cold start injector connector
18. INSTALL ENGINE WIRE TO N0.3 TIMING BELT
COVER
(a) lnstalt the wire clamp on engine wire to the wire
bracket.
(b) Install the engine wire with the bolt.
(c)
Connect the following connectors and wire :
• Alternator connector
• Alternator wire
• Oil pressure switch connector
19. INSTALL INJECTORS AND DELIVERY PIPE
(See steps 1 and 3 to 6 on pages Fl-116 to 119)