Assigning A Name To An Fm/Mw/Lw Station Or Sw Page - Radio Shack DX-398 Owner's Manual

4. While and
PAGE
repeatedly press
TUNING
to select the page where you
want to store the frequency.
The page's number
under and the name of the
PAGE
page's country appears as you
press
TUNING
each page, the number of the first
available empty memory location
in that page flashes next to
Note: If you wait more than 10
seconds to press
TUNING
, PAGE and MEMO
ing. If this happens, start again at
Step 3.
5. Press
ENTER
frequency to the flashing memory
location. The receiver beeps and
a bracket appears around the
number where you stored the fre-
quency.
Notes:
• If the receiver's memory is full,
MEMOFULL appears when you
press a number key.
• To replace a frequency you
stored with a new frequency,
repeatedly press
or to select a new
TUNING
frequency, press
hold down the number key cor-
responding to that memory
flash,
MEMO
or
appears
ASSIGNING A NAME TO
AN FM/MW/LW STATION
or For
.
OR SW PAGE
MEMO .
To help you easily identify stored fre-
quencies, you can assign a name (up
to 8 characters) to an FM, MW, or LW
memory location, or to an SW page.
1. Select a band (see "Selecting a
or
2. Repeatedly press
stop flash-
3. For an FM, MW, or LW station,
to assign the
4. Press
5. While the cursor flashes, turn
TUNING
, then
M/MEM
location for about 2 seconds.
The receiver beeps and stores
the new frequency in the mem-
ory location.
Band" on Page 18).
PAGE
the page number where you
stored the desired frequency.
use the number keys to enter the
desired memory location number.
. A cursor flashes
EDIT
under the displayed frequency for
about 30 seconds.
until you see the
MANUAL TUNING
first character you want to use.
to select
29