Motorola MTH800 Feature User Manual page 81

Emergency Private Call and Emergency Alarm
If the address type is set to Private and Emergency Alarm is
enabled, press the Emergency button to send the emergency
alarm to the address configured by the Service Provider.
When those requirements are satisfied the Emergency Call is
initialized.
Changing Folder or Group
See Group Call section on page 37.
Entering or Exiting Emergency Mode
Upon entry into Emergency Mode any existing call or service
other than packet data service will be aborted or cleared
down.
In Emergency Mode, the terminal will automatically reject
Phone, PABX and Private Calls, and will not monitor the
groups in the user selected scan list. If an ATG is the
selected group, however, the terminal will monitor the sub-
groups associated with the ATG. The terminal will remain in
Emergency Mode until you exit it.
Press and hold the Emergency button to
enter Emergency Mode.
When the MTH800 is Off, press this button to
power the MTH800 On in Emergency Mode
(if configured).
The terminal exits Emergency Mode and
switches to the Home display:
• If you press and hold the Exit soft key during an
Emergency Group Call.
• If the infrastructure ends the Emergency Group Call.
Sending an Emergency Alarm
Your MTH800 will send an Emergency Alarm to the
dispatcher (if configured by your Service Provider):
• Automatically, upon entering Emergency Mode.
Emergency
Folder 1
Talkgroup 1
Hello
Optns Exit
73