Residual Risks; Risk Reduction; Operation - Ryobi RPW36X120HI5 Original Instructions Manual

■ Make sure the air in the hose and pump
is released before you turn on the product.
To remove the air in the hose and pump,
connect the water supply to the pump
using a garden hose, connect the trigger
handle to pump using the high-pressure
hose, disengage the trigger handle lock,
and press the trigger until there is a steady
flow.
■ Exercise caution to avoid slipping or falling.
■ Keep firm footing and balance. Do not
overreach. Overreaching can result in loss
of balance.
■ Only use accessories
recommended by the manufacturer. The
use of improper accessories may cause
injury.
■ Never leave the
unattended. Turn the product off. Do
not leave the product until it comes to a
complete stop.
■ Be familiar with the controls. Know how to
stop the product and bleed the pressure
quickly.
■ Stay alert and exercise control. Watch what
you are doing and use common sense.
■ Do not use the product when you are tired,
ill, or under the influence of drugs, alcohol,
or medication. A moment of inattention
while operating the product may result in
serious personal injury.
■ Do not use the product if the switch does not
turn it on and off. Any product that cannot
be controlled with a switch is dangerous
and must be repaired.
■ Keep a minimum distance of 30 cm when
cleaning vehicles. The high-pressure jet
may damage or burst vehicle tires and/or
tire valves.

RESIDUAL RISKS

Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
■ Injury caused by the high-pressure jet
– Avoid pointing the high-pressure jet to
people, animals, and to yourself.
■ Injury caused by kickback
■
■
It has been reported that vibrations from
handheld tools may contribute to a condition
called Raynaud's Syndrome. Symptoms may
include tingling, numbness, and blanching of
the fingers, usually apparent upon exposure
that are
to cold. Hereditary factors, exposure to cold
and dampness, diet, smoking, and work
practices are all thought to contribute to the
development of these symptoms. There are
product running
measures that can be taken by the operator to
possibly reduce the effects of vibration:
■
■
■
If you experience any of the symptoms of this
condition, immediately discontinue use and
see your physician.
STARTING AND STOPPING THE PRODUCT
To start the product:
1.
2.
3.
4.
– Always hold the handle or the trigger
wand firmly with your two hands.
Injury caused by inhalation of aerosols
Wear appropriate respiratory mask.
–
Injury caused by exposure to noise
Wear ear protection.
–

RISK REDUCTION

Keep your body warm in cold weather.
When operating the product, wear gloves
to keep the hands and wrists warm.
After each period of operation, exercise to
increase blood circulation.
Take frequent work breaks. Limit the
amount of exposure per day.
WARNING
Injuries may be caused, or aggravated, by
prolonged use of a tool. When using any
tool for prolonged periods, ensure you take
regular breaks.

OPERATION

Connect the nozzle to spray wand and
connect the spray wand to trigger handle.
Connect trigger handle to the water outlet
of high pressure cleaner using the high-
pressure hose.
Connect the water inlet of the high
pressure cleaner to the water supply
using a garden hose.
Open the trigger to release the air in the
hoses and high pressure cleaner.
3