Troubleshooting - Ryobi RPW36X120HI5 Original Instructions Manual

TROUBLESHOOTING

Problem Possible causes
Machine does Drained battery
not start
Deffective battery
Fuse has blown
Fluctuating Pump is sucking air
pressure
Valves are dirty, worn
out, or stuck
Pump seals worn out
Motor buzzes Low voltage or low
temperature
Machine stops Fuse has blown
Drained battery
Thermal sensor activated Leave the high pressure cleaner for 15
Nozzle partially blocked
Fuse blows Fuse too small
Machine Air in inlet hose/pump
pulsating
Inadequate supply of
mains water
Nozzle partially blocked
Water filter blocked
Hose kinked
Machine often Pump/spray handle is
starts and stops leaking
by itself
Machine starts, Pump, hoses, or other
but no water accessory is frozen
comes out
No water supply
Water filter blocked
Nozzle blocked
8
Solution
Charge the battery.
Replace with compatible battery pack.
Bring the product to an authorized service
centre for service or repair.
Check that hoses and connections are air
tight.
Clean and replace the part or refer to a local
distributor.
Clean and replace the part or refer to a local
distributor.
Activate the trigger of the spay handle.
Bring the product to an authorized service
centre for service or repair.
Charge the battery.
minutes to cool down.
Clean the nozzle.
Bring the product to an authorized service
centre for replacement.
Allow the product to run with open trigger until
regular working pressure resumes.
Check that the water supply corresponds to
the specifications required (see model tag).
Avoid using long, thin hoses.
Clean the nozzle.
Clean the filter.
Straighten out hose.
Contact your nearest authorized service
centre.
Wait for the pump, hoses, or other accessory
to thaw.
Connect the water inlet port to a water supply.
Clean the filter.
Clean the nozzle.